on 02-12-2008 12:07 PM
Hi,
I try to upload data to Z cube. If I try to upload with one month selected (30.000 records), the upload not finish and in the monitor the update rules are with yellow light.
If I try to upload with day 1 to 15 selection (11.000 records) finish Ok, and after I can upload with selection day 16 to 30 and it works fine.
I check the update rules and it's ok.
Have you any idea what is the problem?
Thanks in advance.
Hi,
I check trans. ST22 but not dump's.
I wait for 3 hours, but it not finish and I cancel load. If I load in two separate uploads them finish in 20 minutes.
Any idea?
Thanks.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The detail tab in rsmon shoul give you some information.
You can also check in sm58 if there is any luw corresponding to your load. If yes you can see the log there or execute it manually.
Do the checks in both systems (R/3 and BW) for all transaction listed in post (sm37, sm50, st22, sm58). In previous post was no clear if you checked them in both system.
Hi Ivan,
Regarding your case ..
Since you said it's yellow, it means it's not finished yet right ..
Could you wait longer .. (perhaps, the system needs longer time ).
Then is that any error .. ?? Have you checked to tcode: st22 ..
Regards,
Niel.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks for your reply,
in SM37 the job finish OK, and any process run in SM50.
Any idea?
Thanks.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
May be u have some routines in update rules thats y it is taking much time. Did u check in Sm37 whether the job is failed or still active and also in Sm50.
Khaja
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.