on 02-12-2008 4:04 AM
Hi everyone,
i m not able to perform init for 2LIS_01_S001.
but full load is working fine.
When i check status it says:
Error message from the source system
Diagnosis
An error occurred in the source system.
System Response
Caller 09 contains an error message.
Further analysis:
The error occurred in Extractor .
Refer to the error message.
Procedure
How you remove the error depends on the error message.
Note
If the source system is a Client Workstation, then it is possible that the file that you wanted to load was being edited at the time of the data request. Make sure that the file is in the specified directory, that it is not being processed at the moment, and restart the request.
Can any one tell right steps to perfrom init.
thanx in advance.
/sachinkumar
2LIS_01_S001 - Customer
Check in your source system whether it is active
I think someone is editing or changed and not activated yet
If active, replicate in BI side and upload data.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
when you execute an INIT delta extraction, you need to make sure no update occurs in table S001.
That means you need to deactivate update of this LIS table during your Init delta (Also, make sure during this period, nobody creates documents that should update S001 otherwise, they would be lost for LIS and BW)
Hope this helps.
AJ
Hi,
This is a Time stamp error
You need to Replicate the respective Data source from the corresponding source system and Activate the Transfer Rules and load again
If you are in Production system you cannot activate transfer rules directly
Go to SE38 --> run the Program RS_TRANSTRU_ACTIVATE_ALL --> mention the infosource and click execute. this will activate the transfer rules and try to reload
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.