no data in rsa3 extract checker

[Former Member]

hai all,

in r/3 extraction i have replicated some data sources into bi ..but in tc code rsa3 when i try to check data in the replicated datasources it saya 0 records selected how do i get data into the replicated datasources ...please guide me ..thanks

[Former Member]

Please check by chance u r checking it in BI system or in source ( r/3 ) system.

Regards,

Mahendra

[mathew_muthalaly]

Hi,

You could also check if there is any relevant application data in the system.

Mathew.

[Former Member]

What datasource is it ?

If its LO - did you perform setup tables ?

Follow LO Extraction Steps...from SDN.

[Former Member]

hai,

thanks for the rsponse.it is full upload..so i tried to laod set up table in oli*bw..it says no active extract structue or no bw connected with the message number M2630

. i do not understand the meaning of it where shopuld be the problem and how should i get it sorted.

[Former Member]

Is it a full load or a delta load? If it is a full load check the data in setup tables. Have u done the statistical setup???

Khaja

[Former Member]

hai khaja ,

thanks for the rsponse.it is full upload..so i tried to laod set up table in oli*bw..it says no active extract structue or no bw connected with the message number M2630

. i do not understand the meaning of it wher e shopuld be the problem and how should i get it sorted.

[Former Member]

Is ur data source in active version activate the DS in RSA5 and then check in RSA6. And also check the RFC connection between bw and R3.

Khaja

[Former Member]

hai khaja,

i did it connectivity b/w BW and r/3 is ok ..ds in active version only

[Former Member]

still r u getting the same problem,

if yes check stepup table. i think someone was deleted stepup table.

[Former Member]

just wanted to make sure if you are checking RSA3 in R/3 system and not in BW system.

Regards

Rohini

[Former Member]

hai rohini,

thanks, i checked rsa3 in r/3 only not in bw.