DRIVER PROGRAM FOR /SMB11/BL_MMPO_L

[Former Member]

HI ABAPERS

i need driver program for this form.

thnks

pardeep

Edited by: pardeep kumar on Jan 29, 2008 4:00 PM

[Former Member · Accepted solution]

go to se11 and give TNAPR table

and say display then press ControlshiftF10

in the SFORM tab give the above form name and press F8

you will get the corresponding program.

You will only get if it is configured against that print program in the NACEansaction

generally the configuration for standard forms would be there

Regards,

Nageswar

[Former Member]

hi

good

When you will create the LOGO node in the smartform. there is CONDITION tab you can put your condition there.

Create 4 Logo node in your smartform at the same position and in each logo node put the condition in the condition Tab. IF sy-uname = 'UNAME1' then LOGO UNAME1 will be called do it forall the logos.

thanks

mrutyun^

[Former Member]

Hi Pardeep,

The print program is

/SMB40/FM06P .