on 01-25-2008 2:08 PM
Can anyone explain where do the settings for what are all the columns(parameters like materials,operations etc that are appearing in the tabular column) in CM25 transaction is done in spro
Std settings are saficient to run the transaction..please come up with specific requirement or issues if any if you face in CM25
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
you can do these settings in spro
SPRO-Logistics-pp-capacity req.planning-capacity levelling-
overallprofiles(enter your profile)
Double click on planning table profile-
Double click on layout id
select the layout id line & cliclk on definition of charts
You will find 3 charts.
now check the grouping key for your chart.
Again go to SPRO same route & go to layout keys in capacity leveling(table lines)
enter yyour grouping key & click on change
you will get the neccesary fields for selection.
select the fields you want & deselect the fields not required.
now click on sequence heading & here you can change the sequence of the fileds to display.
I know this is a bit confusing , but at least try doing this.
I think this is the most clear way in which anybody could explain.
Thanks
Shailesh Nadkarni
User | Count |
---|---|
102 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.