Feature can not be recognized

[Former Member]

It seems I am facing a problem with feature can not be recognized for leaving action (PA40)

Leaving is supposed to have MSN 20 with program generated 1PAPA/FEAT000MSN20 but my client has different program generated which is $P00003U. How do I change it?

[Former Member · Accepted solution]

Hai..

Check if it helps u

Activating features

In client 000, start the RPUMKG00 program (set parameter 'Type of activation' to '1'). The 'Unicode checks activate' indicator is set in the programs that are generated as a result. If you change any features, repeat this action in the relevant clients. Read doc b4 using this program.

[Former Member · Accepted solution]

what is generate feature TCODE? Is it se38 for running the above program? I execute it however I have a message says "When recognizing the predecessors, youmay not specify a feature because the reorganization with subsequent activation can not be performed for a subset"

Edited by: Dian Santioso on Jan 24, 2008 11:59 AM

Edited by: Dian Santioso on Jan 24, 2008 12:09 PM

[Former Member · Accepted solution]

As explained by Mr. Ram, use the t-code SE38 and run the program RPUMKG00 to generate features.

[Former Member · Accepted solution]

I use se38 and generate the feature. However the error message "feature can't be recognized" still appeared once doing leaving action PA40; MSN 20 is still $P00003U.

Is there any other way? Thanks

[Former Member · Accepted solution]

Hi,

Iam facing the same issue while saving work shecdule rule in IT0007 and while executing further actions. How did you resolve this? Could you please share this with me ?

Thanks in advance.

Madhavi

[Former Member · Accepted solution]

My case has not been solved yet. I generate the feature use Tcode se38 and the program changed however I didn't change at Client 000 as Ram told.

I still figure this out with my company and will get back to you as soon as the problem solved.

Did you try to Client 000? what happened?

[Former Member · Accepted solution]

hi,

you have to run that program in 000 client only, all the other clients will be automatically updated after that.

Edited by: kiran amrute on Jan 28, 2008 8:03 AM

[Former Member · Accepted solution]

Coooooooool Dude !

This solved my Issue. Thanks a lot.

Diana,

You may follow the same. Run it in 000 client.

Madhavi

[Former Member · Accepted solution]

Thanks for solving the problem

Edited by: Dian Santioso on Jan 29, 2008 4:39 AM