Skip to Content
0
Former Member
Jan 22, 2008 at 02:31 PM

Physical inventory posting

169 Views

Hello users,

My problem comes with the posting of the physical inventory for oil-based materials.

After creating a physical inventory document, when entering the inventory count, the difference is calculated based on the test conditions entered in the QCI (temperature, density and so on). This will result in the correct values for all units of measurements.

However, when this count is posted in a material document, I run into two problems:

- all the QCI conditions parameters are reseted to 0 and lost (in the material document), even though the calculations have been made correctly.

- the document contains the new value that I entered, but the calculated values, represent only the difference between initial stock and actual stock counted.

Could someone please explain what is going on?

LE: My first question, about the conversion conditions is more or less answered: it is that this parameters are not needed, so they are dropped and the conversion mode changed to automatic.

But the question about the values still remains....

Thank you,

Daniel Balta

Edited by: Daniel BALTA on Jan 23, 2008 11:27 AM