on 11-09-2017 9:17 AM
Hi
I have a main cube A and its 4 sub cubes A1, A2, A3, A4. All sub cubes are copy of main cube and there transformations are also copy of main cube's transformation. Sub cubes A1, A2, A3, A4 are filled from main cube A.
Sub cubes A1, A2 and A3 are filled successfully but when I run DTP of sub cube A4 its shows following error:
"Calling number range object 0CALQUARTER for dimension DT ( )"
I run RSRV and check "Comparison of Number Range of a Dimension and Maximum DIMID" but no error found.
How can I resolve this error??
Thanks
Imran Shafiq
Hi Imran,
You can check this KBA for more details:
1920296 - Error calling number range object * for dimension
Use: Tcode SE16 -> RSDDIMELOC -> InfoCube
Reset the BID* in SM56 then execute program RSDD_RSTMPLWIDTP_GEN_ALL, and reactivate the cube.
Regards, Andras
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Imran,
Sure, you can. But always check if the symptom is the same as in the KBA and follow the resolution steps strictly.
About program RSDD_RSTMPLWIDTP_GEN_ALL, you can find more information here:
1152453 - Termination generating InfoCube write program
Regards, Andras
Hi, solution provided by Andras worked also for me. Thanks.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Andras
Thanks, report RSDD_RSTMPLWIDTP_GEN_ALL resolved the issue.
Regards
Imran Shafiq
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.