Process Chain Running Twice

[Former Member]

HI!!

I ran by error twice the same PC, now in the maintenance log, I found 2 logs, in the first one the Start step is in green and the others steps are in gray, in the second log the start step is in yellow. In the Displaying messages in found this:

This message means that step 001 is currently being started. The

additional parameters give further details on the step itself:

As far as I understand I have to delete the second log, but no idea how to do that.

Is this the solution? or anyone knows another way?

Thanks & Regards

[Former Member · Accepted solution]

Right click on the second run of the process chain start variant.. display all jobs..the one which is running shd be active.

Double click on this and click on job details button.. note the server name and Work process id and let your basis team know to kill this process id..so that the second run of the process chain can be terminated.

[former_member345199]

Hi,

First and foremost let me advice you to be very careful while doing this.

You can start from SM37, find the process WID/PID then go to SM50 or SM51 and kill it. Once its done come back to RSMO and check the request, it should be red but again manually force to red and save by clicking on the total status button in the status tab. This shuld ensure that the process is killed properly.

The next step will be to go to targets that you were loading and remove the red requests from those targets.

Note: For source system loads you may have to check if the request is running in the source system and kill if needed and pull it again.

But for BW datamart delta loads u may have reset the datamarts in case u are going to pull the delta again.

Refer

Regards,

JituK

[former_member184494]

Also once you have killed the job , there is a very good possibility that the chain is still shown as active. There go to Process chain in the menu bar and select marge active version and then you can run your process chain again.

Arun