Regarding Info packages

[Former Member]

Hi ALl

Do v hv to create 3 infopackages( Full,init,delta) for each and every Datasource. For Ex I hv 0COSTCENTER_ATTR & 0COSTCENTER_TEXT,so is it mandatory to create 3infopackages for each of these data source?

Also, I hv 0COSTELMNT_ATTR & 0COSTELMNT_TEXT, for these DS’s, I created 3 info packages(Full init delta) for Text Data source respectively, but I was just able to create 1infopackage(Full) for Attribute DS, Is it like some DS’s support Full,init,delta,,,and some of them just support Full?? Plz advice

[Former Member · Accepted solution]

Hi Raihaan,

Its not mandatory that we have to create 3 IP,

all these Full,Init,Delta can be achieved through 1 IP.

But its good practice to keep all you IP separate, this is usually followed in BW to keep separate IP for Full,Init,Delta & also for easy reference.

Technically it can be achieved through 1 IP.

Regards.

[Former Member]

Yes, most of the master datasource donot support Delta.

One infopackage is good enough to act as Init, Full and delta.

You can create multiple though as per your convenience.

RSA6 or RSA2 - > Check the delta process.

[Former Member]

Hi,

It is not mandatory to create 3 info packages for each and every data source..... But it is good to maintain 3 IPs instead of 1... We can identify the IPs easily, which ip is for what load...

Well for ur second question... U r rite if the DS wont support the delta then u are able to create only 1 IP....

Khaja

[Former Member]

Hi,

Go to ROOSOURCE table.There u can gat the information about which DS supports FULL & which supports DELTA ...

GTR