on 01-17-2008 2:24 PM
Experts,
after taking a usage decision, I want all inspection results to be transfered back to the batch.
But if a result is out of spec, it gets a negative valuation, then I get the warning 'batch could only be partially valuated' and the result of this char is not writte back to the batch.
How can I have also the negative results recorded in the batch?
Thx
In the batch level make sure that any value you are giving will be accepted.
master data required
Batch and batcth charectristics
MIC- copay from batch charectristics
Material specification with same MIC's.
Quality plan with same MIC's.
In the batch charectistics make sure that the range is more tahn that in MIC so that any value is taken or in batch chereristics -check box - aditional value allowed in value tab page is active.
With this setting you should be in the position to get the results
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks, that was helpful. I marked the additional value box in the class char and that did the trick.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
12 | |
10 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.