Skip to Content
avatar image
Former Member

How to activate the LT replicaiton Configuration Sattus?

I tried to configure SAP SLT to replicate between SAP and HANA database. The configuration is good. and both connection (to SAP and to HANA) are successful when testing. But I cannot activate the configuration.

Does anyone know how to activate the configuration? or where can I find any log file to troubleshooting?

Thankscapture.jpg

capture.jpg (41.0 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Oct 26, 2016 at 07:48 PM

    Hello Scott,

    We can check the logs in the same T-code we have a tab to check the logs.

    Also please check the DB connection RFCs

    Also please check the below RFCs are working or not.

    1.Source to SLT RFC connection and 2. SLT to HANA DB RFC.

    Can you check if you can find anything in SLG1?

    Please paste the logs that are captured form LTR T-code.

    Thanks,

    Phani.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 20, 2016 at 12:11 PM

    Hi Scott,

    You can activate/start the configuration by clicking on adjacent button shown in your screenshot.
    If its not getting started then please check if your system have enough work processes.

    Also you can use attached example to set no. of jobs.

    Regards
    SJ

    Add comment
    10|10000 characters needed characters exceeded