Skip to Content
0
Former Member
Jan 14, 2008 at 07:50 PM

Load data stream and source data basis problem

21 Views

Hi gurus,

I created a Souce data basis (S1) to load hierarchy from 0gl_account.

But when I try create and set a Load from data stream I got the following errors:

-

-


InfoObject 0GL_ACCOUNT not contained in InfoObject catalog of source data basis S1

Message no. UCF7039

Diagnosis

One of the following problems has occurred:

Case 1: Source data basis S1 does not have an InfoObject catalog for the defined characteristics.

Case 2: An InfoObject catalog is defined for source data basis S1, but it does not contain InfoObject 0GL_ACCOUNT, which was specified on the entry screen in Customizing.

Case 3: The name of InfoObject 0GL_ACCOUNT (which was specified on the entry screen in Customizing) contains an error.

System Response

The customizing settings cannot be saved.

Procedure

Proceed as follows depending on which case applies:

Case 1: Create an InfoObject catalog and make sure it contains the desired InfoObject 0GL_ACCOUNT. Specify this InfoObject catalog in the InfoObject Catalog for Characteristics field in source data basis S1. Save the source data basis S1.

Case 2: Add the desired InfoObject 0GL_ACCOUNT to the InfoObject catalog for characteristics in source data basis S1. Save the source data basis S1.

Case 3: Enter the correct InfoObject. Input help (F4) is also available.

-

-


I can´t even access mapping tab.

I already have 0gl_account in a char catalog in BW and this catalog in source data basis.

Could you help/say Why this is happening?

Thanks in advance,