on 01-08-2008 4:07 AM
Hi,
I am trying to send a material from R3 to XI using the transaction BD10.On executing i get 2 messages:
1. 1 master IDocs set up for message type MATMAS
2. 0 communication IDoc(s) generated for message type
MATMAS.
However, when i send by WE19 , the IDOC is sent sucessfully.
As we19 is successfull, I think that i have done all the ALE settings as well.
Please help.
Thanx.
Hi Prashant,
Yes You have to maintain
Port to XI from R/3 (TA-WE21)
Partner profiles in R/3 (TA-WE20 ) and
Distribution model in R/3 (TA-BD64)
Cheers,
Jag
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Prashant,
If you are not able to create the "Communication Idoc", then the problem is outbound side only.
Check you distribution model. Before this check your Partner Profile, tRFC port and RFC destination and make sure you are using correct port.
And try with different materials no's range.
Regards,
Naveen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
However, when i send by WE19 , the IDOC is sent sucessfully
--->
Check your partner profile--> outbound parameters
have you selected option Transfer Immediately.
If not then after executing BD10, you will have to go to WE19 to send Idoc manually.
Better use Transfer immediately option so that executing BD10 will trigger IDoc
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
1, The filter in not mandatory
2. The process code in hte partner profile should be MATM so you got ot change that.
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
U may check the following:
1. The filters in the distribution model
2. Check the process codes specified
Regards,
Prateek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Prateek,
I checked the distribution model.....Under the message type(IDOC) added , the display is "NO FILTER SET".
Do i need to set any filter, if so plz guide me thru dat.
And the process code for Inbound parameter is set as :
"APLI :Inbound IDoc: Individual Processing ".
Do tell me if i need to change dat.
Thanx.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.