on 01-07-2008 8:25 AM
Hi PP Gurus,
I have a BOM for finished product ,
Finished product---- 1 cv
COMPONENT 0.5 CV
WHEN I AM PREPARING PRODUCTION ORDER FOR FINISHED PRODUCT TAKING QUAN 3 CV , IT TAKES REQUIREMENT OF COMPONENT IS 2 CV NOT 1.5 CV.
PL HELP
VIKAS
Dear Vikas
Enter decimal places 3 for the UOM in transaction CUNI. The requirements rounds up because the decimal places for UOM configured doesnot allow this.
Regards
Soundararajan M
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Can u change the qty of finished product from 3 to some other value??
Check this. Hope u have not maintained some minimum lot size in material master
Also check for scrap...
Is this error appearing for this material only or even in others
See this error is a common error and there were many threads related to this.......and above given options were some of the main cause of the issue
Please check all these and revert
Rgds
Hi,
check bom header details as base quantity for the header material.
reqard points if useful to you
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vikas
Probable reasons could be either of following
1) Check whether alternative units of measures have been maintained for assembly / components - If any
2) Assembly / Component scrap value
Try to change the qty of finished product and then see the proposed qty and try to relate it with above reasons
Check and revert
Rgds
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.