Skip to Content

RFC Function Modules issue transferring large OTF file

Hi,

I need to transfer the output of a Smartform (large OTF file) using an RFC enabled FM between 2 systems.

My FM works fine if there's no logo on the output but fails when the logo is there as the file size increases considerably.

Has anyone else had this kind of problem and how it was resolved? Or suggest a way of getting round it?

Thanks,

Lesley

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Oct 31, 2017 at 05:55 PM

    "fails"? Could you clarify?

    RFC itself is pretty robust, so I'd look at the sender or receiver. I've tested up to 100MB RFC payloads without issue. Easy thing to try is sending to a local RFC destination and see if it is received OK.

    Add comment
    10|10000 characters needed characters exceeded

    • OK, so try it with a local RFC destination (i.e. the system sends to itself).

      You could also check OS level RFC error logs in AL11, in DIR_HOME, look for any dev_rfc... files with a timestamp that corresponds to your attempt.