cancel
Showing results for 
Search instead for 
Did you mean: 

Seeburger Classifier

Former Member
0 Kudos

Hi,

I am using Seeburger Classifier module.

I have a doubt over there.While doing module configuration,how we are going to decide about the value of parameter classifierAttID .

From where i will get the parameter value for parameter name classifierAttID

Thnanks,

Anoop

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Anoop,

attID parameter value can be chosen from you. It's not required to be classifierAttID.

In case you are using Seeburger Message Tracking (FileStore) AttID parameter value is used as a key defining classier attachment.

Regards

Naycho

former_member267355
Active Participant
0 Kudos

Hi,

This parameter is used to specify an attachment, in which the information

about the classification is attached to the XIMessage.

If no attID is set, the defaultname “MessageTypeReport” will be used.

Regards,

Sakthi

Former Member
0 Kudos

HI,

Though I dont have much experience with classifier module but what i know is:

classifierAttID:

This parameter is used to specify an attachment, in which the information about the classification is

attached to the XIMessage.If no attID is set, the defaultname MessageTypeReport will be used.

Paramter name should be classifierAttID and parameter value wil be classifierAtt. that what should be mentioned in AS2.

Thnx

Chirag

Former Member
0 Kudos

Hi Chirag,

Thanks for reply.I know about that..

But my question is how we are using this classifirAtt paramter..it is there in manuals i have seen over there..but how this paramater value is decided.Can,we use something else other then this.

and from where we are going to get this value to use in modules if this classifierAtt isn't used.

Thanks,

Anoop