Skip to Content

input DATE in MIC as result

Dear Nitin Jinagal and all,

Kindly did you reach to a solution to these issue. cause i face it

also any one reach to get date format in MIC,

thanks in advance

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Nov 01, 2017 at 01:49 PM

    Dates cannot be directly entered into a MIC. It is not supported.

    Work arounds:

    1) Enter the date into the inspection description of the MIC.

    2) Enter the date as a number: i.e. 20171101 for today into a quantitative characteristic. If you want this as an actual date on a batch level characteristic, you can use a second date characteristic that uses a dependency (and FM), to take the entered number from the original characteristic and parse it out into a date format that becomes the value for the batch characteristic.

    Add comment
    10|10000 characters needed characters exceeded

    • Not my solution. I didn't do it. You need to research dependencies and work with a programmer (for FM). The details of this is way beyond an internet forum. And understand that the date is not actually seen as a date in the inspection lot and is not directly reportable as a date from the inspection lot. Only the batch.