Logon error in EasyDMS

[Former Member]

Hi All

I have installed EasyDMS 6.0 SP 01, Patch 01.When I try to login to EasyDMS, after entering the user id and password, i am encountering the following error message "Logon failed (RFC_ERROR_LOGON_FAILURE)"

Could anybody suggest remedy for the same?

Regards

S.Sivakumar

[Former Member · Accepted solution]

I have the latest version and i've tried with all combination of setting case sensitive for both user & pass.

Also tried password in all upper and all lower.

Espen

[Former Member · Accepted solution]

In SP)9, by deafult case sensitive should be checked..u should not uncheck it

second hting - go to windows-system32 folder, you will find librfc32.dll there..in case u are using non unicode version of easyDMS, check the version of this dll.and post it here..for unicode version of easyDMS it should not matter..

also, does your save password entry is checked and u r using the existing old password/or typing the password again?

rgds,

anu

[Former Member]

I'm running GUI 6.40, but as far as i know, GUI version should be irrelevant, as they should not be using SAP GUI.

Any other pointers or ideas?

Regards,

Espen

[Former Member]

Hi,

Try with the latest EasyDMS version that is SP09. easyDMS should take care of caps/small/integres.. some special chractares might cause problems. so, try the latest version and paswword without special characters..check if it works or not..

regards,

anu

[Former Member]

I had sililar problem when integrating SAP with AutoCAD

The Problem is

i was able to logon to 4.7 & ECC 5

But i am not able to logon to ECC 6

I had SAP GUI 6.2 installed before the problem.

When i uninstalled SAP GUI 6.2 &

installed SAP GUI 6.4 the Problem was solved

i was able to logon to ECC 6

May be in your case too ...

[david_deeg]

Hi,

Easy DMS creates dump messages in the backend if an error occurs. Use tc ST22 to check your dumps,

the dump message will tell you more about the login problem. I´m quiet sure that the short text of your dump

will be "RFC no authority".

To use Easy DMS you need several RFC authorities, on the basis of my experience 90 % of all problems with

Easy DMS are caused by missing authority.

[Former Member]

Hi,

I have a similar problem. WHen logging on, with a username and password i know to be correct, i get the login failure. After three times, i get locked out, as i should do. Hence the user is correct, and so is the system, connection etc.

Any ideas?

Regards,

Espen Leknes

[Former Member]

Are you sure you have a user in the backend system to which you

are connecting?

[Former Member]

Hi,

there is the authority for RFC missing.

Turn on the trace to check, witch RFC funtion-group authority is missing.

To turn the trace on click on the SAP logo in the EasyDMS logon screen.

regards

Iring