Skip to Content
avatar image
Former Member

test equipment in qm

dear experts,

now i am working test equipment management in QM module.in that i have 10 equipments to calibrate every month.what are the steps.

i tried like this

1) IE01

2) IA01

3) IP41

4) IP10

Now my query

1)when i am creating in IA01 it is not selecting only it is showing general task lists only.

2)then i created general task list then it is ok .then it is creating insp.lots but in created staus only. .how to change to Release status to results recording

thx&regards

prasad

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Dec 17, 2007 at 04:00 AM

    hi prasad

    whatever you have done is correct,but how are maintaining the 10 equipments,whether you are creating one maintenance plan and attaching all the equipments or creating individual maintenance plan for all the equipments.

    iam not able to understand your problem regarding the issue 1

    Regarding the issue 2 i think you have not assigned any inspection characteristic or system is not able to pick up the task list for the inspection lot, in the task list kindly check whether the status is Released and check whether you have specified the inspection point as 300 for equipment and whether you have assigned the characteristic to the operation.

    Regards

    thyagarajan

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 20, 2007 at 06:06 AM

    thank u my query was solved

    Add comment
    10|10000 characters needed characters exceeded