Skip to Content
avatar image
Former Member

Dimension check during putaway in Inbound Process

Hello All,

Good day, please can you suggest for me for the below scenerio how ti process.

1. Prodoct has a dimension maintain lengh 1270 Width 400Height - 1000

2.Product dimension maintain 2000 height, 600 width and lengh 1000 but system is allowing to do pwty in the bin

3 Bin type and capcity check is maintain requried.please can you let me know how dimnesion of product and bin please help with the configration .. thank you

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Oct 20, 2017 at 03:58 PM

    Hi all

    Small correction check for point 2 product dimension against bin type check

    Regards

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 21, 2017 at 08:14 AM

    Hello Jack,

    EWM carries out the Capacity check only based on weight, volume(fixed numeric), DIMENSIONLESS( system not calculating volume!!! ) Capacity figure( Material & HU type) and max quantity capacity.

    In your case, you are expecting system to calculate the volume based on your DIMENSIONS( L,W, H ) which you should not expect.....you just need to maintain the NUMERIC volume in the product master capacity field & check the system behaviour ...

    Hope that answers your question...

    Best Regards

    Monir

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 21, 2017 at 08:45 AM

    Oops!! Typo error.....Correction to my earlier answer is as follows...

    you just need to maintain/default the NUMERIC volume in the Storage Bin master capacity field....

    Add comment
    10|10000 characters needed characters exceeded