Materials not in integration model

[Former Member]

Something has happened in my R3/APO Development system where lots of Materials are not in any Integration Model. They should be, and checking in our prod system they are.

I've de-activated and re-activated Int Models but to no avail.

How can I check/update materials to be part of an Integration Model?

[Former Member]

Forgot to update and close.

Problem was with corrupt program variants. Have recreated variants and all is ok.

[Former Member]

Hi,

You can check CFM5 whether your material is in active integration model or not.

Hope this helps!

regards

Yogendra

[Former Member]

Hmm, it seems my RIMODGEN (CFM1) variants are corrupt.

They look OK but I deleted one and recreated it.

It then picked up all materials the original one didnt.

[srinivas_krishnamoorthy]

You can always check the content of the integration model using CFM4. You can select the line item that shows content (eg material line if it is a material integration model) and click on details icon.

One way to retrieve the old integration model will be to go to CFM6 transaction and select the earlier variant based on the time stamp, and then save it back as a new variant.

[Vaidhya]

For material master integration, the indicator in MARC table should be set properly. During the integration model activation if the MARC table is locked for some reason, this does not happen.

Pl. refer to the following reports

RAPOKZFX - Set APO indicator in MARC table after activation

RCIFIMAX - Consistency between integration models and MARC table

RCIFMTDE - Log the deactivated material masters

Hope this helps!