on 12-11-2007 6:19 AM
Hi,
I have maintianed following Text in PO item level in info record text .
Evaporated Salt, meeting these requirements:
Sodium Chloride: >99.8 wt%
Calcium/Magnesium: <20 ppm
Calcium Chloride: <5 ppm
Water Insolubles: <50 ppm
Approved:______________________________ Date:_____________________
But when i see in print preview , it showing as below
Evaporated Salt, meeting these requirements:
Sodium Chloride: >99.8 wt%
Calcium/Magnesium: <(><<)>20 ppm
Calcium Chloride: <(><<)>5 ppm
Water Insolubles: <(><<)>50 ppm
thus some unecesaary special characers are appearing in Print preview.
what could be the possible cause for this?
how this can be rectified?
Thanks
Akkshaya
Go to the place where you define the PO text, in that text editor screen choose 'Change Editor' to line editor mode (you can find this in one of the Menu item), remove those unwanted character, then save it.
Best regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
If you do that in the PO then you have to do it every time, I already mentioned in my 1st reply is that go the place you define the PO text (change in the configuration for purchasing text). Do u know who define that in the configuration (tcode : SPRO), ask that person to do it for you if u r not the one define it.
Best regards,
User | Count |
---|---|
101 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.