on 12-08-2007 1:58 PM
Hi,
I have some qns regarding QM:
1) When I changed the UD from acceptance to rejected, I am unable to change the characteristics result of the inspection lot.
Could anyone advise is there any way to change the characterics result so that it can aligned the UD.
I used QE01 and QE02, but I am unable to do it.
Please advise.
Yeo,
It depends on the status of the characteristic which you are trying to change .If the status is 5 which means "processing is complete" then you cannot change it .Please check this and let me know .You can check this in QE51n or qa32-results.The status will be the third column for that particular characteristic.
Reward if helpful or let me know if you have any questions
regards,
Naik
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
When you goto QE51n ,there are a lot of small icons above inscpection caharacteristic line .It is the ninth icon from left (unlock icon ).Highlight the character and click this icon .This will allow you to change the value.Only,if the UD has not been made and the character is a long term inspection characteristic.
Regards,
Naik
Hi,
Use transaction QE51N to record / change results. If you have already recorded the results for a characteristics, then the characteristics are valuated & closed. Hence, you will have to set the characteristics to processing & then change the results.
Regard,
Prashant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.