Skip to Content
0
Former Member
Dec 01, 2007 at 07:56 AM

Call transaction Tcod..... mode 'N'/'P' where option N not terminating

371 Views

Hi,

Call transaction Tcode using mode ['A','E','N','P'] ...

If breakpoints are set in a tcod called using the CALL TRANSACTION tcod USING itab variant,

these are not actually reached in 'N' mode. The system tries to insert data in the Debugger screen; the call ends with SY-SUBRC = 1001

and the message "Batch input data is not available for screen SAPMSSY3 0131" (S 00 344).

I tried this in release ECC 6.0 but its not termintaing as soon as it reaches the breakpoint in tcod.

I tried before this in the previous release and it was working fine.