on 11-29-2007 5:40 AM
I have created new OUPUT TYPE (ZINB) (using Tcode NACE) to print billing invoice by coping(copy all) a existing Output type and attached only a new smartform.
But new ouput type is not displaying to print invoice document (VF02).
(Give message 'Output ZINB is not defined')
Please help me to identify this problem.
Pradeep
Hi Pradeep,
Please assign the billing type in the output procedure. And then set the condition records, you will see the output type.
Reward points, if helpful.
Regards,
Gaurav Grover
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Pradeep,
Your new output type ZINB should be assigned to the relevant output determination procedure along with the billing type.You can check this in V/25 and also check out whether a valid condition record exists for this output type in VV33,if not create one using VV31 using ZINB output type.
Hope this should resolve your problem.
Rgds,
Aram K.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Pradeep,
In [VF02] go to the output screen and check the determ analysis to find out why the output type was not triggered.
Regards
Nadarajah Pratheb
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Did you mentained this output type in output procedure which you same in the billing doc. type detailed screen?And have you assigned this to billing type in the config.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.