Skip to Content
avatar image
Former Member

mapping problem

Hi all,

1. My source structure is inv_source_mt - > row -> seqno guino docnumber

where row is 0..unbounded and seqno , guino , docnumber are 1:1

2. My targrt structure is same as above

problem is that even if there are 3 records coming of row in source structure

After mapping i get only row record in target

kindly help

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

7 Answers

  • avatar image
    Former Member
    Nov 21, 2007 at 07:19 PM

    if your target is same as the source then you don't need any mapping at all

    are you doing any dynamic configurations or any other reason why you are doing message mapping?

    Thanx

    Aamir

    Add comment
    10|10000 characters needed characters exceeded

  • Nov 21, 2007 at 07:38 PM

    Hi Sunil,

    Did you map the correpsonding node for Row also?

    map the row node in the source and target if you have not done already.

    Regards,

    Ravi Kanth Talagana

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 22, 2007 at 04:17 AM

    Sunil,

    Didn't understand your question well.

    Ur source and target is :

    MT

    +Row

    ++seqno

    ++guino

    ++docnumber

    right...

    But didn't understand the problem....

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 22, 2007 at 04:30 AM

    Hi ,

    my source and target structure are

    MT

    +Row

    ++seqno

    ++guino

    ++docnumber

    and i have mapped the row node as well

    I need a xml file on the receiving side with the same structure as source and hence i have used same target structure as the source

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 22, 2007 at 04:53 AM

    > 1. My source structure is inv_source_mt - > row ->

    > seqno guino docnumber

    >

    > where row is 0..unbounded and seqno , guino ,

    > docnumber are 1:1

    >

    <b>> 2. My targrt structure is same as above</b>

    Go to Message Mapping:

    click on the Source Message Type and then click on the Target Message Type...and the click on"Map Selected fileds and substructure if names are identical" (it is just below the design tab).

    This can solve your problem...only if source and target are same...

    Note: It might be possible that u created the two diff DT and MT with the same structure..if it is then check the occurance of the Target messag...it should be same as source:)

    Thanks

    Farooq

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 22, 2007 at 05:12 AM

    hi sunil,

    can you check your <b>message mapping in Test option</b>

    make your<b> target Row structure is same as Sourse means I:unbound</b>..

    hope this will help

    regards

    HONEY

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 22, 2007 at 05:22 AM

    Thanx for all your replies....

    As told, i am not using mapping now and it wrks

    Thanx once again

    Add comment
    10|10000 characters needed characters exceeded