on 11-21-2007 12:02 PM
Hello Experts ,
While configuring my RFC-XI-Webservice scenario when i am trying to execute my abap report in which i have called my Function module and RFC .I have created RF in myR/3 side .and I created the scenario in my XI system.when I run the RFC from R/3 system.it is giving the above error.
Can you suggest how can i resolve this issue. I am doing this configuration using Shabarishs Weblog 3387.
Please guide.
Regards
Saras Jain
Hi,
If your SAP Version is less than or equal to 4.6, then you have to configure the Idoc/RFC Adapter for sending the messages. So just try to now your version first.
And the other error could be the the RFC....just go to transaction SM59 and test your RFC. And also check the settings where you configure your function module with RFC.
Reward with Points if helpful
Regards
Sai Ganesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Also check ur Function Module...Check Wheather its Remote enabled or not...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Saras,
Does the RFC Destination type - TCP/IP works fine in your sender system?
Check the same.
Regards,
Sudharshan N A
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
have you configured the RFC adapter and the rfc destination correctly?
Ref:
Sender- /people/michal.krawczyk2/blog/2005/03/29/configuring-the-sender-rfc-adapter--step-by-step
trouble shooting rfc/soap - /people/shabarish.vijayakumar/blog/2008/01/08/troubleshooting--rfc-and-soap-scenarios-updated-on-20042009
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
9 | |
8 | |
6 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.