Multiprovider Problem

[Former Member]

Hi,

I have created one Multiprovider on one ODS and i have choosed all the chars and KFs from ODS, and there are 2 Unit chars but i am alble to get only one Unit Char (Local Currency) into Multiprovider but not the another one (Base Unit of Measure) even though i have selected all chars and KFs from that ODS

Even i have tried to drag into Unitchars dimenstion but i couldn't do.

Could you kindly suggest me.

Thanks,

Shaliny. M

[Former Member]

Shaliny,

Just collect all the infoobject which are available in the ODS, so that it will collect all the keyfigs and chars..So that automatically it will collect the Unit charecteristics too... Then do the identification...

Regards,

Gattu

[Former Member]

But not able to get the one Unit Char into Multiprovider eventhough i have selected all KFs and Chars

Plese any suggestions for this

Thanks

[Former Member]

Unit Chars will be automatically dragged into the MP once you drag the Keyfigures like Amount or Quantity.

Have you dragged all Keyfigures onto the right side ?

You can just Click <b>ALL</b> which will Identify all Chars and do the same for Keyfigures.

[Former Member]

Hi,

yes i had selected all chars and KFs and also i have click ALL and checked..and activated also. but not able to get that unit char

Any more suggestions please

[Former Member]

Check the source unit for all Keyfigures ..jst in case is 0UNIT used in the first place...do you have any keyfigure like Quantity ..