Skip to Content
avatar image
Former Member

SUM: Error on phase MAIN_TRANSEXEC/RUN_RSAIMMERGE_TRANS

Hello,

We are currently installing add-ons via SUM after installing of base S4HANA server 1610FP2. We used Maintenance Planner to have up-to-date installation. However, during the SUM Execution phase, we encountered the error below:

==================

Checks after phase MAIN_TRANSEXEC/RUN_RSAIMMERGE_TRANS were negative!
Last error code set:
Single errors (code <= 8) found in logfile 'RSAIMMRGTRANS.ELG'

ERROR:
Batchjob RSAIMMERGE_UPG_SHD failed.
Detected the following errors:
# /installations/OND/SUM/abap/log/MRUPGAIM.OND:
A2 EAIMMERGER_SHD 008 ......................:"SAPKE60840"
A2 EAIMMERGER_SHD 008 ......................:"SAPK-60840INEAHR"
A2 EAIMMERGER_SHD 016 Requests are suitable; merge will be performed.
A2 EAIMMERGER_SHD 022 Command file for "SAPK751XPRAMRGHEAD" successfully created
2 ETG011 "Excluding ACGRs for SAP transports"
1EETG010 "CREATE_COMMAND_FILE:" "INSERT_NEW_COMM for" "SAPK751XPRA90000001" " "
A1EEAIMMERGER_SHD 221 "CREATE_COMMAND_FILE": "INSERT_NEW_COMM" returns return code sy-subrc = "3" ("DB access error")
A1EEAIMMERGER_SHD 021 "MERGE": "CREATE_COMMAND_FILE" returns return code sy-subrc = "3" 

=================

I checked the job RSAIMMERGE_UPG_SHD and it finished successfully.

I already raised a high priority ticket but SAP has no reply yet.

Thank you in advance.

Add comment
10|10000 characters needed characters exceeded

  • This is caused by some leftovers of previous upgrade in one of the internal table.

    Solution is to delete all the SAPK740XPRA* entries from that internal table and then repeat the phase. As it has to be confirmed by SAP first , so reaching out to SAP will be helpful.

  • Get RSS Feed

0 Answers