Skip to Content
avatar image
Former Member

Idoc getting struck in sm58, randomly

Hi Team,

I am trying to push data from CRM system to PI through Idoc_AAE.

but some Idocs, are getting struck in sm58, than I have to delete those Idoc from sm58 and than reprocess Idocs's again.

Again, some will pass while other will get struck with same error

Anything which I can do?

idoc.png (77.9 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Oct 02, 2017 at 07:50 AM

    Hello Nunu,
    You have to check that all steps, including GW are configured correctly. Check SAP Note 2474395 with references to typical problems in that case. And of course, check the following article and blog:

    Configuring Java IDoc Adapter (IDoc_AAE) in Process Integration

    How to create and configure Sender Idoc AAE Scenario – PI 7.3

    Best regards,
    Vadym

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 02, 2017 at 06:52 AM

    Hi nunu,

    Have you checked if the control segment is right comparing with the IDOCs processed correctly?.

    Is your PI up when the error appears?, it seems the idoc_aae adapter was down.

    Regards.

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 02, 2017 at 03:22 AM

    Hi,

    Can you check if this thread helps

    https://archive.sap.com/discussions/thread/3275602

    Regards,
    Mark

    Add comment
    10|10000 characters needed characters exceeded