on 11-07-2007 7:24 PM
Hello all,
could you please guide me in creating/configuring the base unit measure field of material master record(basic data view). Please note that i already used CUNI t-code and i could not find the units which were already there in that field like case, each, unit etc.
please help me out.
Even if the answer is little bit helpful i'll reward points
regards
kxd
hello ,
thanks a ton to you both for clarifying my doubt. it was really helpful.
thanks once again
regards
kxd
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
In CUNI, you cannot see all the units at the same time. You need to change the dimension. Use the dropdown to select a different dimension.
Case, Piece, Each, etc are available in AAAADL (no dimension), Gram, KG, Ton etc in Mass and so on.
For a particular UOM to appear in the Material Master or to use it for purchasing, it needs to be defined as commercial UOM.
Lakshman
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
In your UOM configuration for the units you configured, check if you activated the check box "Commercial Unit of Measure". If not already done, select it. Then try to create Material master again.. See if it works
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.