Skip to Content
avatar image
Former Member

Lumira Desiger - Map state selected by default

is it possible to set a state default in Map Lumira Designer when I open my map.

xample: I have a USA map with population key figure. When I enter in map will enter with Florida state checked.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Oct 03, 2017 at 01:46 AM

    Hi Alberto,

    Unfortunately the map component does not have a setSelectedMember() method to highlight a default selection. You could try applying CSS to highlight relevant region to simulate selection.

    Alternatively, on startup you could filter your data source to the state of Florida so that only this state appears initially on the map. The only disadvantage of this approach is that the rest of the state outlines and USA outline will not be visible.

    Additionally, you could evaluate the Partner mapping extensions on the SAP App Center to determine if they can better address your needs.

    Regards,

    Mustafa.

    Add comment
    10|10000 characters needed characters exceeded