Idoc-To-File-Material Master.

[Former Member]

Hi,

Please let me know the Partner Type and Partner Function to create Partner Profile for Material Master data in SAP R/3 side.(Outbound).

Rgds

Ruchitha.

[Former Member · Accepted solution]

We use Partner Type as LS - Logical System as it Points to PI/XI.

I cannot see Partner Function in WE20 though... Did you mean that?

[Former Member · Accepted solution]

HI Barry,

Thanks for your Response.....

Once we select partner type LI -> under that Outbound Parameters -> Partner Function will be seen.......

So I want to Know what we have to provide in that Partner Function.

And even I want to know Under the message control tab what details I have provide like

1> Application :

2> Output type :

3> Process code :

Please let me know.....

Rgds

Ruchitha.

[Former Member · Accepted solution]

Hi Ruchita,

There are three ways in which the IDOc will be sent to target system

1)Change pointer

2) Using the std process codefunction module which is used for the master data.

3) Message control which is used for transactional data.

Message Control is usally used for message control settings.

Function module is attached to process code which is called through this process code and which fill the IDOC segments.

Thanks and Regards,

Chirag Gohil

[Former Member · Accepted solution]

I must be mising something...

Is this INBOUND or OUTBOUND? File to Idoc makes me think it is Inbound

Do you mean Message Type?

All I can see Partner No, Partner Type, Partner Role

Message Type, Message Code and Message Function

In the Inbound Parameters we only add the Message Type - MATMAS

Process COde is either MATM ot MAT2

[Former Member · Accepted solution]

This outbound.

And it is Idoc To File.....For this I want to know the settings in Sap R/3.

Thanks

Ruhcitha

[Former Member · Accepted solution]

Depending on the process for generating the Idoc, outbound the settings are done in SALE rather than WE20 for this.

[Former Member · Accepted solution]

Hi,

This is expalined both the scenarios:

Please follow the below process for configuration:

Pre-requisites for Inbound IDoc to R/3 from PI:

Configuration required at Xi side:

Go to IDX1: configure the port.

Go to IDX2: load the DOC metadata.

Go to SM59: Create RFC destination which points to R3 system this is require in the case where your IDOC is sent to R 3 system,

Configiration required at R3 side:

Maintain Logical System for PI (SALE transaction):

Maintain Partner Profile for XI system(WE20):

Pre-requisites for Outbound IDoc from R/3 to PI:

Configurations required in R/3:

Maintain Logical System (SALE)

Define RFC Destination (SM59) which points to PI system

Maintain Port (WE21)

Maintain partner profile. (WE20):

Maintain Distribution Model (BD64):

DO let me know if you need more information

Thanks and Regards,

Chirag Gohil.