Skip to Content

how to use revaluation function in analysis office of embedded BPC

I need to use the revaluation function in analysis office of embedded BPC, the function and planning sequence has been define under T code RSPLAN, and a variable rev-factor has been define under function as well, I have add the planning sequence under planning objects of AO, when I run the PS, it run successfully, but the problems that the "rev-factor" did not pop up and I can not change the rev-factor when run this function, anybody can through a light?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Sep 28, 2017 at 07:58 AM
    Add comment
    10|10000 characters needed characters exceeded

  • Sep 30, 2017 at 09:58 PM

    I depends how that rev-factor is defined in your PF. If you defined it as a variable then you should use same variable in AO Query, put value of the variable in some cell and refer to that cell in Planning objects of AO.

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 03, 2017 at 05:08 PM

    I have defined the variable in the as following, in AO, we use the standard query "/ERP/SFIN_A01_IRQ0001" as the data source, I did not see where we can add this variable to the query in AO.

    Add comment
    10|10000 characters needed characters exceeded