on 10-30-2007 6:02 PM
Hi All,
I have a problem when creating a receiver IDoc from XI to R/3.
I have successfully tested the IDoc when populating the receiver information from the payload. However I want this information to be populated automatically based on the logical systems.
When I do this I get the following error in the IDoc in R/3:
EDI: Partner profile inbound not available
In the control record the sender information is all correct but in the recipient information the partner Number with type LS is populated, but port is not populated.
I have done the following steps.
the sender is a Business Service so I have created a logical system directly adapter-specific identifiers in the sender service in the integration directory.
In the receiver business system I have imported the logical system into the adapter-specific identifiers in the ID from that specified in the SLD.
In the receiving R/3 system using SALE/BD54 I have created a logical system for the source system.
In the receiving R/3 system using we20 I have created a partner profile of type LS with the same name as the source logical system.
IN PI/XI system in transaction IDX1 Ive created a port (SAP<SID> where <SID> is the system ID of the receiving R/3 system) and the client of the R/3 system, and the RFC destination of that system (<SID>CLNT<clnt>, as specified in SM59).
In the IDOC Adapter (receiver) I have entered the RFC destination and port matching those created above. All checkboxes are UN-checked eg. take sender from payload, take receiver from payload, Apply control record values from payload, etc. are all NOT checked.
I think that Ive done everything correctly, but I get the error in we02 in R/3: EDI: Partner profile inbound not available.
Any help will be greatly appreciated (and rewarded, obviously).
Thanks,
Matt.
Hi,
I had similar problem in my project,in we20 delete the idoc metadata nd again reload it in parnerprofiel it will work.
UPdate the thread.
Regards,
phani
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Matt,
Can you please copy paste the exact error message....In your error message it will show you Exact partner Number / Logical System name and other parameters...just compared if you have all parameters set in your partner profile comparing to error message...
If you can giev screen shot of both..then probably would be easy to point out error.
Hope this will help.
Nilesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
9 | |
8 | |
6 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.