Skip to Content
avatar image
Former Member

Problem in adapter monitoring on newly installed pi7.0

hello all,

i am working on file to jms scenario. File adapter is picked the file. but jms adapter is not received. in adapter monitoring no messages are displayed. Messages are storing into smq2. in sxmb_moni Q.Status showing stop. sxi_cache showing Unable to refresh cache contents. we installed pi7.0 newly, is there any configuration problem? Plz suggest me

Thanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    Oct 26, 2007 at 07:24 PM

    The messages are getting blocked in the inbound Qs. Check if the message data is good. If you think everything is fine, use the delete button available in SMQ2 at 2 levels deeper to delete the problematic LUW.

    VJ

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 27, 2007 at 05:39 AM

    1. initially make sure the Queus are registred ( i think it might be)

    2. the status of the message in the queue did it errored out ( System faileure ) etc SMq2

    3. data might be stuck in the queue when the reciveiver systemn is not able to retrive that...there might be some problem in the reciver adapter also...just reativate the JMS adapter....

    If the mesage in the Smq2 is failed then definatley some error in the JMS adapter side....reactivate the JMS receiver adapter...sometimes the Adapter monitoring will not show th updated status of the adapter...run the interface again and check...

    Add comment
    10|10000 characters needed characters exceeded