Outbound payload not visible in sxmb_moni

[Former Member]

Hello Guru's,

I have a issue in message monitoring (sxmb_moni). I can't see the outbound payload for the most interfaces.

Do I have to set a parameter somewhere? Does anyone has any suggestion?

Kind regards,

Kamran

[Former Member]

Hi Kamran,

If ur messages are synchronous then try the Steps mentioned above.

Pravesh

[Former Member]

Hi people,

Thank you for your replies.

Im going to set those parameters to 1 cuz in our system it had a value of 0.

This goes for all of the messages synchronous and asynchronous. Is there a difference between if we have a asynchronous interface?

Kind regards

Kamran

[Former Member]

TRACE_LEVEL applies to Sync and Asyc.

RUNTIME LOGGING applies to Async.

RUNTIME LOGGING_SYNC applies to Sync.

[nisarkhan_n]

outbound payload should be visible even you have not define these parameters, these parameters will give you all the trace of the XI Pipeline steps.....but when the message enter the pipleine if no errors are there then the Outbound Payload should appear....do you have any errors in SXMB_MONI

[Former Member]

Hi,

If the interface is synchronous you will not see the message unless the parameters listed are set.

However, if the interface is asynchronous, the message should always be visible.

Kind regards

Colin.

[Former Member]

hi

Is Your scenario working fine after adding thease paramteters.

Regards,

pradeep.

[Former Member]

Hi there,

The majority of our interfaces are asynchronous and we dont have any errors. After setting these parameters we can see the trace of the XI Pipeline Steps. And in one of these steps we can see the oudbound message. Is there another option? Because we couldn't see it at first so it's not set at default.

Kind regards,

Kamran

[nisarkhan_n]

check this blog.....

/people/michal.krawczyk2/blog/2005/05/10/xi-i-cannot-see-some-of-my-messages-in-the-sxmbmoni

when tou set these parameters you will c the messages in SXMB_MONI that means you dounle click on 1 messages, the message details starts with inbound message and to c all the steps which messges goes trough you have to increase the trace level......might be that blog will be helpfull to you

Message was edited by:

n Khan

[Former Member]

Hi

This usually happens when you make certain changes in your Mapping.Check the mapping in your IR part.What type of mapping are you using.

Thanks

[Former Member]

Goto transaction SXMB_ADM -> Integration Engine Configuration -> Specific Configuration

Have a look at the following parameters:

RUNTIME LOGGING

RUNTIME LOGGING_SYNC

RUNTIME TRACE_LEVEL