Skip to Content
avatar image
Former Member

Material master - Z fields

I am trying to fill in the values into Zfields.

I am able to make the BAPI work in a report.

When I do the same thing in the proxy, it does not work.

I checked the code. every thing seems to be fine.

The data is good when it is being passed onto the BAPI extensionin and extensioninx structures.

Can anyone give me hints

reg

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Oct 11, 2007 at 12:01 AM

    Hi Naveen,

    Check this note 568513, if you are using ALE-IDoc for updating Z* fields of Material Master.

    An entry for each user-defined field must be created in table T130F. This table forms the basis for the field selection (see the IMG 'Assign fields to field selection groups' and 'Maintain field selection for data screens'). You can only copy data from the BAPI interface to the corresponding database table if the respective table field is stored in table T130F and if the field selection is set in such a way that the field is ready for input.

    The fields for the T130F entry can be maintained as follows:

    FNAME = MARA-ZZCUS1(for example name of the tomerfield)

    FGRUP = 211 (Field group 211 to 240 possible)

    PSTAT = EDVKALBQPSZXCFG

    KZREF = X

    FGROU = GR_GLOB

    You can maintain the table using transaction SE16.

    Hopes it helps you.

    Ali.

    Message was edited by:

    Quadri to add SAP Note.

    Add comment
    10|10000 characters needed characters exceeded