Skip to Content
avatar image
Former Member

Delta Mechanism : COPA extractor

Hi,

There is one requirement in our project where we have to find possible reasons which can break delta mechanism in case of COPA extractor.

1.One reason is if re-alignment has run for the COPA datasource on R/3.Qusetion is: how can we find whether re-alignment has been run on r/3 side except indicated by data load failure? Is there any table which captures this information?

2. Any other possible reason which can break the delta mechanism in case of COPA extractor?

Regards,

Phani

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Oct 10, 2007 at 06:15 AM

    Hi Phanindra,

    There is another very common error with COPA Datasources Delta Failure

    Please see <b>my response</b> in below thread

    difference-between-copa-and-logistic-delta-mechani

    Hope it Helps.

    Thanks

    CK

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Chitrarth,

      Thanks for replying but still did not have the solution for following question:

      Is there anyway we could find it out if re-alignment has been done on R/3 system for CO-PA ? Any table capturing this information?

      Regards,

      Shiv

  • avatar image
    Former Member
    Oct 25, 2007 at 08:21 AM
    Add comment
    10|10000 characters needed characters exceeded