on 09-14-2017 4:47 PM
Hi experts,
i'm trying to understand the behavior of a DTP in a process chain.
This is my scenario:
BW 7.5 SP7
The process chain load a DSO in Full Mode from different sources.
The last step is a DTP that load the DSO with itself, for updating some fields.
Now, there are two indexes, that are not updated by any routine, which are systematically reset to 0 when the process chain is over.
If i run manually the DTP the two indexes keeps their own values.
Launching the DTP through process chain get different result from manual launch, i try to create a new DTP, i try to insert the DTP in a MetaChain, i try to execute the DTP through an ABAP Program recalled by the process chain but i get the same result, only the manual launch produces the correct result.
I don't understand why, it's possible to debug the process chain?
Any ideas?
Thank you.
Hi,
no, there is no reference to the execution user in the transformation...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Giordano,
Do you have any reference to the execution user, e.g. sy-uname in the transformation?
Kind regards,
Andrey
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.