Skip to Content
avatar image
Former Member

receiver determination

hi all,

y we hav *'s in receiver determination for recevier and service in receiver determination .

regards,

keerthi

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Oct 06, 2007 at 08:07 AM

    Hi,

    The receiver determination determines from the configuration the valid receivers for

    a sender with a special sender service.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 06, 2007 at 09:57 PM

    Keerthi,

    Receivers can be dynamically determined based on the data in the source. since you do not know the potential receivers for a given interface at design time you see the "*".

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 07, 2007 at 05:49 AM

    Hello Keerthi,

    Receiver determination is basically to route the message exactly to the destinated receiver. Its purpose is completely understood once you have multiple receivers and if u need to route the message to each receiver based on a condition(out of n number of recievers)

    You can specify the condition through configured receivers

    eg :

    if VTWEG = 1 route to "recv_serv1"

    if u hav a service u wil specify service, if u hav party u will specify the same thing

    Hope it finds u useful

    Regards

    Venkat.

    Add comment
    10|10000 characters needed characters exceeded