Skip to Content
avatar image
Former Member

Variant configuration

Hi Guru's

i have configuarable product A and in this one more configurable product B is there. Now i am assigning the class of B to class of A in CL22N. Now due to this i will get first charactristics of B then of A to configure the product. But suppose i put some charactristics of B into the class of A (these charactristics are common to both) then system is showing only once these charactristics i want this way only but i want to know will this give any complexity or will it create the problem.

what will be any implications of this. Pls thorow some light on this.

thanks and regards


Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Oct 06, 2007 at 10:49 AM

    Class 300 can have mutiple calsses,,,ther is not problem in doing this.

    What is nore important is the char...which if repeated, then it will be displaied only once.

    There is not problem in this it is a normal behavior.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Rajesh

      Thanks for ur input. This means system will behave normally if the characterstics of the subassembly(configurable) are same as of header material only it is displayed once.

      thanks a lot