Skip to Content
avatar image
Former Member

(Production Issue) Witems without Agents - Reg.

Hi,

I have a question about finding out the witems without the agents. I know that we can use SWI2_ADM1 Txn to find out witems without any agents. But, strangely in my system(ECC 6.0), this report is giving some of the workitems that have agents. I don't know why. I know that though this gives the agents, these agents may not be valid at current time(compared to the time when the witem was generated). But, this is not the case. These agents were created long back and still exist. And the wflow log shows this agent for the witem.

But, still these witems show up in this SWI2_ADM1 report. I know i can just see all the witems, one by one, and if the agent is not there, then either fwd or execute that witem only.

But, i want to know if i can rely on SWI2_ADM1 or not.

As this is a production issue, pl respond as soon as you can.

Thanks in advance,

venu

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Oct 05, 2007 at 04:42 PM

    Yaa you are right this transaction cannot be relied but still you have to use it. I use this approach

    Go to table SWWUSERWI and search with user id Blank. If it is blank that means it is without agent. This is very useful:))))

    <b>Reward points if useful and close thread if solved</b>

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 07, 2011 at 05:27 AM

    Issue resolved

    Add comment
    10|10000 characters needed characters exceeded