Skip to Content
author's profile photo Former Member
Former Member

Error in releasing billing document to accounting

Hi All,

While releasing a billing document , i am getting error as : No Valuation segment exists in the material master record for product xxxxx.

However on further analysis it is found that in order to valuate line item for COPA system is reading valuation segment in different plant where material is not created or extended.

Also it gives message as " The system tried to read the product cost estimate according to costing key XXx as defined in the CO-PA Customizing settings."

I have checked settings also.

Even costing key has been defined for plant specific and assignment to any characteristics also defined correctly. (KEPC)

Thanks in advance

Avinash

Add comment
10|10000 characters needed characters exceeded

2 Answers

  • Best Answer
    author's profile photo Former Member
    Former Member
    Posted on Sep 28, 2007 at 02:33 PM

    Please check in the define access to standard cost estimate if there is any specific plant defined to read the cost estimate. You can check this under plant used for reading cost estimate.

    Assing points if helpful

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Sep 28, 2007 at 10:00 AM

    Hi,

    Check whether the material master is created in the plant where you are trying to record. Also check in obyc, whether that material valuation class is correct or not

    Radha

    Add comment
    10|10000 characters needed characters exceeded