Image in VC.

[Former Member]

Hi Experts,

I am new to VC.

I need to get data from R/3 in RFC which is sending data in table in the VC project i need to extract the data from table and for every data i have to display corresponding Image at the portal end along with the data. I need some help in how to go about in this case. where to apply the logic ?

and if i am getting the data in a table would i extract it from the table so that i can display the corresponding image for the data.

Regards,

Sanjyoti.

[Former Member · Accepted solution]

Hi Sanjyoti,

You can add a bound form for the table (meaning add a form and connect it to the table) and add an image control to the form.

Apply the logic in the image tab of the image control.

Hope it helps,

Shay