Skip to Content
author's profile photo
Former Member

File to RFC

Hi ,

i'm doing File to RFC scenario.. for this data was loading into R/3 database.. from file... but the first record of my file only loaded into DATABASE.. the remaining records are not loaded into database..

so, can any one suggest me that what is the problem for this... does we need to specify the loop any any where..for process all the records..

plz suggest the if any settings fare need for this requirement...,..

Regards

Babu

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

4 Answers

  • Best Answer
    author's profile photo
    Former Member
    Posted on Sep 28, 2007 at 06:29 AM

    Hi Babu,

    What I think in ur case when u r doing the Message Mapping the occurance of ur target message(RFC) is 1..1 . However the sender file adapter is picking all the record.

    Due to this reason only one record is being populated in the DB table.

    Try sending each record in the file as separate message and ur problem will resolve.Use Recorsets per Message in Content conversion parameters of ur Sender File adapter.

    Pravesh

    Add comment
    10|10000 characters needed characters exceeded

  • Posted on Sep 28, 2007 at 06:00 AM

    Hi BABU,

    Can u paste the code...?

    Regards

    San

    there is a Way.

    Add comment
    10|10000 characters needed characters exceeded

  • Posted on Sep 28, 2007 at 06:17 AM

    What is ur import parameters of ur function module?

    Make sure ur file messages and the import parameters are same?

    Check ur RFC code?

    Send ur codes and datas.

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Posted on Sep 28, 2007 at 06:31 AM

    chek ur data type is put to unbounded or not?

    Add comment
    10|10000 characters needed characters exceeded