Skip to Content
author's profile photo
Former Member

Unable to send workitem in email

Hi all,

I am using <b>RSWUWFML2</b> report to send mail to external email id. But i am not getting the email. My email id is maintained in SU01D. I am passing task no TSXXXXXXXX to the report. This task will send mail to my SAP INBOX (Got mail to my sap inbox).

I debugged the report and i foundout that the task i have created is not present in the table SWWWIHEAD. So data is not being selected for my task. I have no idea where i went wrong.

Regards,

Gautham

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Posted on Sep 27, 2007 at 04:04 PM

    Hi,

    Required proper settings in SOST and also in SCOT transactions.

    Thanks and Regards,

    Prabhakar Dharmala

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Posted on Sep 27, 2007 at 04:32 PM

    This program is used to generate notification for workitem that has been sent to your SAP Inbox. You must take care that the User that is mentioned in the Step of the background job has a valid email address maintai in SU01d and the communication method is Email. Please check whether there are any entries for your email in SOST Transaction.

    as far as your requirement I feel the communication method in your SU01d transaction should be email. Then only mail will go.

    Add comment
    10|10000 characters needed characters exceeded

  • Posted on Sep 28, 2007 at 08:03 AM

    Hi Gautham,

    When you run the program without the tasknumber do you get any mails then? Also check if you set the option for only new workitems, if you did this could limit your selection. You could check in table SWWWIHEAD if your task is there.

    Regards,

    Martin

    Message was edited by:

    Martin Nooteboom

    Apparently you posted this question twice. Please close one.

    Add comment
    10|10000 characters needed characters exceeded