cancel
Showing results for 
Search instead for 
Did you mean: 

LO Data Correction Issue-High Imp

Former Member
0 Kudos

Hi Guru,

While doing re-initialisation for Purchasing data(LO Cockpit),some how we got wrong data into BW ( may be because we have not cleaned the delta queue).

Now for the few affected Purchase Order, I want to correct the data.

Is it possible to re fill the SET UP table for those particular POs only and load into BW as a repair full request, without disturbing the present Delta which is going on dailly?

Thanks in Advance.

Abhishek

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

You can only fill setup tables if the delta queue is empty...try load delta until theres no data in queue and then try to fill setup tables again..

Regards

Former Member
0 Kudos

Hi ,

When I try to reinitialise the SET UP table in quality,it gives a msg: Data in 2LIS_02_HDR still need to be transfered.

What this means: Is it is data in delta Queue or or data present in SET UP table or in Queued delta Job??? I am not getting any clue

Thanks

Abhishek

Former Member
0 Kudos

Dear Abhishek Kumar,

i dont think so..

Experts please correct me

Regards

venu

Former Member
0 Kudos

H

Yes you will first have to clear the setup table and then fill it with repair PO's.

Then do the selective deletion for those PO's from ODS. And then run selective repair full load. Then you can continue with delta loads.

Regards

Rohini

Former Member
0 Kudos

Dear Rohini,

How can we select the repair PO's.while filling the setup tables

Former Member
0 Kudos

Hi Venu,

I mean to say is fill the setup table with PO's which have been repaired and needs to be loaded again.

Regards

Rohini