Skip to Content
0
Former Member
Sep 10, 2007 at 04:38 AM

REM - Reporting Point error during Backflushing

1301 Views

Hai PP Gurus,

When i am backflushing in REM (MFBF), System shows following error..

Error reading reporting point information

Message no. RM111

And then system suggests the following reasons...

The repetitive manufacturing profile has been changed in the current session.

You have not defined any milestone operations in the routing.

When creating the product cost collector, no reporting points were created.

But i checked all those things. But the system shows the same error.I could not found anything wrong what the system shows.What would be the reason beyond these.

(Actually first system reads the RP correctly.After that i changed one of the UOM in the BOM component.That particular material is purchased with EA & issued by using Meters.So first i used EA & then chamged to M.For this i maintained unit of issue in material master for that material.Now i changed all those things that means Unit of issue & UOM for the BOM component.So the position comes like prevoius. But the system shows the above mentioned error...)

Expecting your answers...

Thanks & Regards,

S.Ganeshraja